Echo 73724 - Manual (Page 15)

Page 11 Truck Loader Operator’s Manual
Section
5 Troubleshooting
Problem
Probable
Cause
Suggested
Remedy
Improper control
settings.
Use proper settings
Lack of fuel. Fill fuel tank.
Internal engine
problems.
Contact dealer.
Spark plug
disconnected
Connect spark plug.
Dirty, stale, or
contaminated gas.
Refill gas tank with fresh,
clean, unleaded regular
gasoline.
Plugged rotor. Clear rotor.
Vacuuming material
too fast.
Slow vacuuming rate.
Cooling system
pugged.
Clean cooling fans and fins.
Improper oil level
Fill engine to correct oil
level. Refer to Honda
engine operators manual.
Excessive vibration
while running
Drive system
vibration
Check drive belts and
pulleys for bad or worn
areas.
Drive belt too loose
or broken.
Adjust or replace
Plugged rotor. Clear rotor.
Not using correct
belt.
Contact authorized dealer to
order Bear Cat belts
Pulley damaged or
wore
Replace pulley.
Pulley not in
alignment.
Align pulley with straight
edge.
Belt tension too
loose.
Tighten belt or replace
Trailer swings during
towing
Tire air pressure not
correct
Check tire sidewall for
inflation limits
Engine speed too
slow.
Increase engine speed.
Vacuuming to much
material into the unit.
Vacuum debris at a slower
rate.
Engine stalls or stops
Engine will not start
Plugged discharge
tube
Excessive belt wear
Rotor will not turn
Engine overheats
5.0 TROUBLESHOOTING
5.1 GENERAL TROUBLESHOOTING