beautypg.com

4 replacing the drive belt - dl12720, 5 lubrication, Important – Echo DL12653 Owners Manual v.2 User Manual

Page 17: Grease zerk, Warning

background image

12 Inch Debris Loader

13

SERVICE & MAINTENANCE

BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,

AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.

WARNING

Check the condition of the drive belt annually or after every

25 hours of operation, whichever comes first. Replace a

cracked, frayed, worn or stretched drive belt. To replace

the drive belt, proceed as follows:

1. Shut engine off and wait for all moving parts to come

to a complete stop.

2. Disconnect spark plug wire.
3. Remove the belt shield by removing the 8 bolts securing

the belt shield to the housing weldment.

4. Loosen and remove the idler pulley (Figure 5).

5.4 REPLACING THE DRIVE BELT - DL12720

Figure 5.5, Drive belt, DL12720

5. Loosen the 3/8" bolt attaching the engine tie to the

vacuum housing.

6. Loosen the four 3/8 x 1" carriage bolts attaching the

engine plate to the deck.

7. To release the tension on the belt, loosen the jam

nut and engine plate push off bolt located on side of

machine

8. Remove the old belt and install the new belt.
9. Reinstall the idler pulley.
10. Move the engagement lever to vacuum position.
11. Tighten the push off bolts to move the engine away from

the rotor housing until the belt deflection is 7/16" when

a 20 lb. load is placed against the belt (Figure 4).

12. Tighten the four 3/8 x 1" carriage bolts securing the

engine plate to the deck.

13. Tighten the jam nuts to ensure the proper deflection

is maintained.

14. Reinstall belt guide. Adjust so there is 1/8" clearance

between the belt and the belt guide.

15. Move the engagement lever to the start position.
16. Reinstall the belt shield.
17. Reconnect spark plug wire.

Figure 5.6, Grease zerk, DL12720

GREASE

ZERK

5.5 LUBRICATION

Do not over grease bearings. Overfilling can lead to

excessive heat and/or unseating of the seals. Add

grease slowly and under light pressure. Whenever

possible, rotate bearing slowly while lubricating.

NOTE

Polyurea and lithium-based greases are not

compatible. Mixing the two grease types may lead to

premature failure.

IMPORTANT

JAM

NUT

PUSH OFF

BOLT

CARRIAGE

BOLT

ENGINE

PLATE

BELT

IDLER

PULLEY

3/8"

BOLT

The DL12720 has a greaseable bearing located near the

engagement handle and both models have grease zerks

located at the base of the discharge tube. Lubricate the

machine periodically with a lithium-based grease. Extreme

working conditions will require more frequent greasing.

This manual is related to the following products: