Echo TC-210 Serial E14712001001 - E14712999999 - Manual (Page 27)

TC-210 MAINTENANCE
© 9/2014 ECHO Inc.
X7504083607 27
Gear Housing
1. Remove tines (See Tine Removal/Cleaning - Installation
below).
2. Remove gear case cover (A). Be careful not to tear sealing
gasket (C).
3. Support tiller with exposed gear case (D) upward. Add
grease until nearly level with top of gear case (D).
Do not over fill. Too much grease will cause pressure and possible seal failure.
Tine Removal/Cleaning - Installation
Note: Always wear gloves to protect hands from sharp blades.
Stop engine and disconnect spark plug wire before removing or installing tines. Contact with
revolving tines will cause severe injury.
1. Remove retaining pin (E) and slide tine from shaft.
2. Remove weeds, etc. from tines and wash dirt from unit.
3. Clean accumulated dirt and debris form gear housing and
tine shaft.
4. Select "Tilling" or "Cultivating" position, and install tines
facing forward (tilling) or rearward (cultivating).
5. Slide tine on shaft, long hub first. D-hole (hole with flat side)
goes to the outside. (D-hole in outer hub aligns with flat on
shaft.).
6. Install retaining pin (E).
A
D
C
B
E
E