Echo PPF-225 - Manual (Page 18)

18 X7502308106
© 09/2013 ECHO Inc.
OPERATION PPF-225
Lubricating the Guide Bar and Saw Chain
Automatic Oiling System
1. Wipe debris from around oil fill cap.
2. Remove oil fill cap and fill reservoir with a quality, low
viscosity guide bar and saw chain oil.
To prevent plastic deterioration, do not use synthetic or silicone
based oil
Adjusting Automatic Oiler
1. From bottom of gear case, turn adjustment screw (A)
clockwise to decrease oil volume - counter clockwise to
increase oil volume
Note: The automatic oiler is preset to deliver a sufficient oil
discharge volume during normal operating conditions.
During heavy or dry cutting conditions, the oil discharge
volume may be increased to assure adequate lubrication.
If oil is leaking from the bar cover area, reduce the oil
discharge volume. Refill the oil reservoir with each tank
of fuel..
Note: Very little visible oil on the saw chain will provide sufficient lubrication.
Starting Cold Engine
The attachment will operate immediately when the engine
starts, and could result in possible serious injury. Keep
movable parts of the attachment away from objects that
could become entangled or thrown, and surfaces that
could cause loss of control.
1. Stop Switch
Move stop switch button (A) forward, away from the STOP
position.
2. Choke
A
A