Adjusting automatic oiler, Starting cold engine, Ppf-280 operation – Echo PPF-280 User Manual

Page 19

PPF-280

OPERATION

X7502308507

Adjusting Automatic Oiler

1. From bottom of gear case, turn adjustment screw (A)

clockwise to decrease oil volume - counter clockwise to
increase oil volume

Note: The automatic oiler is preset to deliver a sufficient oil

discharge volume during normal operating conditions.
During heavy or dry cutting conditions, the oil discharge
volume may be increased to assure adequate lubrication.
If oil is leaking from the bar cover area, reduce the oil
discharge volume. Refill the oil reservoir with each tank
of fuel..

Note: Very little visible oil on the saw chain will provide sufficient lubrication.

Starting Cold Engine

The attachment will operate immediately when the engine
starts, and could result in possible serious injury. Keep
movable parts of the attachment away from objects that
could become entangled or thrown, and surfaces that
could cause loss of control.

1. Stop Switch

Move stop switch button (A) forward, away from the STOP
position.

2. Choke

Move choke lever (B) to Cold Start Position (

3. Purge Bulb

Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5
times.

4. Recoil Starter

Lay the unit on a flat area and keep movable attachment parts
clear of all obstacles. Firmly grasp throttle handle and throttle
trigger lockout with left hand and fully depress throttle trigger to wide open position. Rapidly pull recoil
starter handle/rope (D) until engine fires (or maximum five [5] pulls).