Echo PPF-280 - Manual (Page 14)

14 X7502308507
© 02/2014 ECHO Inc.
ASSEMBLY PPF-280
ASSEMBLY
Cutting Attachment to Drive Shaft Installation
Saw Chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury
may result
1. Loosen the two (2) screws (A) and remove locator screw (B)
on cutting attachment.
2. Slide the cutting attachment onto the shaft housing until the
hole in the neck of the cutting attachment is aligned with the
hole (C) in the housing. (It may be necessary to rotate the
saw chain slightly to align the internal pinion and drive
shaft.).
3. Insert locator screw (B) into hole (C) and tighten to snug.
4. Tighten bolts (A), clamping the cutting attachment onto the
housing.
Drive Shaft/Power Head
1. Stand power head upright on a level surface.
2. Loosen the drive shaft clamp bolt (A) at engine drive shaft
clamp.
3. Remove dust cap if necessary, and carefully fit drive shaft
assembly to engine making sure that inner drive shaft
engages into clutch mount.
Note: Gear Housing must be aligned properly with engine.
4. Tighten drive shaft clamp bolt (A) securely.
5. Route throttle linkage and ignition lead assembly below fan
housing.
Parts Required: Drive Shaft Assembly, Cutting Attachment.
Parts Required: Power Head, Drive Shaft Assembly
A
B
C
I
A