Echo PAS-230 - Manual (Page 11)

P
RO
A
TTACHMENT
S
ERIES
TM
O
PERATOR
'
S
M
ANUAL
11
Tools Required: Screwdriver.
Parts Required: Barrier Bar
Handle Adjustment
1. Stand in a comfortable operating position with attachment as-
sembled, and position front handle for comfortable operation.
Tighten handle screws.
Barrier Bar Assembly
NOTE
The Barrier Bar may be used with all attachments unless instructed
otherwise in the attachment Operator's Manual.
1. Unscrew bottom bracket of handle, and replace with Barrier Bar as
shown. Adjust handle and secure as described above.
ATTACHMENT SHAFT ASSEMBLY
Tools Required: None
Parts Required: PAS Attachment Assembly
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to
lock-out position.
3. Carefully fit attachment drive shaft assembly into coupler (B)
making sure that the inner lower drive shaft engages into the
square upper drive shaft socket.
4. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft
hole. Insure locator pin is fully engaged by twisting lower drive
shaft. Locator pin should snap flush in coupler. Full engagement
will prevent further shaft rotation.
5. Secure lower shaft assembly to coupler by tightening clamping
knob (C).
A
SSEMBLY
C
A
A
B
C
B
FRONT HANDLE ADJUSTMENT
/
BARRIER BAR ASSEMBLY