beautypg.com

Gear housing assembly, Drive shaft assembly – Echo 99944200485 User Manual

Page 15

background image

99944200485

MAINTENANCE

X7702091904

15

© 08/2013 ECHO Inc.

1. Brush loose debris from blade and coat both sides of blade

with the 50-50 cleaning mixture.

2. Allow cleaning mixture to soften the remaining gummy

residue then wipe it from the blade.

3. Apply clean oil to the entire length of the blade. Be certain

the blade bolts are lubricated.

4. Wipe excess oil from the blade before putting the unit back

in service.

Gear Housing Assembly

Level 1.

1. Clean dirt from the grease fitting (A).

2. Carefully pump grease into fitting (A). DO NOT force

grease. Too much pressure will force grease past seals and
cause damage. Apply 1-2 pumps of grease every 15-25
hours of operation.

3. Wipe excess grease from around grease fitting.

Drive Shaft Assembly

Level 1.

Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid
touching blades whenever possible, and always wear gloves to protect hands.

1. Remove gear housing locating screw (A) and loosen

clamping screw (B). Remove the gear housing assembly
from the drive shaft housing..

2. Pull the drive shaft (C) from the housing, wipe clean and

re-coat with a thin coating [1/2 oz. (15 ml)] of grease.

3. Slide the drive shaft back in the drive housing being careful

not to get dirt on the flex shaft.

Parts Required:

POWER BLENDX

TM

14 oz. or Lithium Base

Grease.

Parts Required:

POWER BLENDX

TM

8 oz. or Lithium Base

Grease.

A

A

B

C