Operation, Adjusting cutting angle – Echo 99944200595 User Manual

Page 12

X7532095607

OPERATION

99944200595

1. Remove support loop handle assembly, barrier bar (if

installed), and mounting hardware from PAS or SRM-SB
power head.

2. Retain parts for future use.

OPERATION

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts
have come to a completestop before removing obstructions, clearing debris, or servicing unit. Allow
unit to cool before performing service.

Note: Refer to your Pro Attachment Series or Split Boom Operator's Manuals for correct engine fueling,

starting and stopping instructions.

Adjusting Cutting Angle

Never adjust cutting assembly with engine running.

Hedge Clipper blades are sharp. Always wear gloves when adjusting cutting assembly, otherwise
serious injury may result.

DO NOT stand hedge clipper on end when adjusting cutting
angle, otherwise serious injury may result.

1. Place unit on a flat clear area. Assure stop switch is in the

“STOP” position.