Echo 99944200532 - Manual (Page 14)

14 X7702092204
© 10/2013 ECHO Inc.
OPERATION 99944200532
OPERATION
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts
have come to a completestop before removing obstructions, clearing debris, or servicing unit. Allow
unit to cool before performing service.
Lubricating the Guide Bar and Saw Chain
Automatic Oiling System
1. Wipe debris from around oil fill cap.
2. Remove oil fill cap and fill reservoir with a quality, low
viscosity guide bar and saw chain oil.
To prevent plastic deterioration, do not use synthetic or silicone
based oil
Adjusting Automatic Oiler
1. From bottom of gear case, turn adjustment screw (A)
clockwise to decrease oil volume - counter clockwise to
increase oil volume
Note: The automatic oiler is preset to deliver a sufficient oil
discharge volume during normal operating conditions.
During heavy or dry cutting conditions, the oil discharge
volume may be increased to assure adequate lubrication.
If oil is leaking from the bar cover area, reduce the oil
discharge volume. Refill the oil reservoir with each tank
of fuel..
Note: Very little visible oil on the saw chain will provide sufficient lubrication.
A