beautypg.com

Avoid hot surfaces, Equipment, Safety hc-152 – Echo HC-152 User Manual

Page 8

background image

8

X7532249501

© 4/2013 ECHO Inc.

SAFETY

HC-152

Avoid Hot Surfaces

• Keep exhaust area clear of flammable debris. Avoid contact

during and immediately after operation.

Never perform blade maintenance procedures while engine is running.

Equipment

Use only ECHO approved attachments. Serious injury may result from the use of a non-approved
attachment combination. ECHO, INC. will not be responsible for the failure of cutting devices,
attachments or accessories which have not been tested and approved by ECHO. Read and comply
with all safety instructions listed in this manual and safety manual.

• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.

• Check that the cutting attachment is firmly attached and in safe operating condition. Dull, loose or

damaged blades should not be used.

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings.

ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a

complete stop before removing obstructions, clearing debris, or servicing unit.

DO NOT start or operate unit unless all guards and protective covers are properly assembled to

unit.

NEVER reach into any opening while the engine is running. Moving parts may not be visible

through openings.

Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or
leaks are found, do not use unit, otherwise serious personal injury or property damage may occur.
Have unit repaired by an authorized servicing dealer before using.