Echo PE-230 Serial 05001001 - 05011200 - Manual (Page 13)

P
OWER
E
DGER
O
PERATOR
'
S
M
ANUAL
13
4. Recoil Starter
Lay the unit on a flat, clear area. Firmly grasp right hand grip and
throttle trigger lockout with left hand, and fully depress throttle
trigger to wide open position. Rapidly pull starter handle/rope (D)
until engine fires (maximum five [5] pulls).
5. Choke
After engine fires (or five [5] pulls), move choke lever back to
“Run” ( ) position. Hold throttle trigger and throttle trigger
lockout fully depressed and pull recoil starter handle/rope until
engine starts and runs. Release throttle trigger and allow unit to
warm up at idle for several minutes.
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke, and do not depress throttle trigger to wide open position.
WARNING DANGER
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1. Stop Switch
Move stop switch button (A) away from the STOP position.
2. Primer
Pump primer bulb (C) until fuel is visible in the "Clear" fuel return
line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Lay the unit on a flat clear area and pull the recoil starter handle (D)
until the engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
D
C
D
A