Echo 73413 Owners Manual v.2 - Manual (Page 13)

10
NOTE: Normal engine output is 3600 RPM no load.
1. Before starting be sure to check engine oil level.
2. Turn engine fuel valve to the ON position, and move choke lever to the CLOSE
position. NOTE: the choke may not be needed if the engine is warm or the air
temperature is high.
3. Depress the clutch pedal and start the engine. Pull the starter cord until light resistance
is felt and then pull briskly.
4. As the engine warms, gradually move the choke lever to the OPEN position.
5. Slowly release foot pedal to engage chipper.
NOTE: Normal engine output is 3600 RPM no load.
1. Check engine oil level before starting.
2. Turn engine fuel valve to the ON position, and move choke lever to the CLOSE
position. NOTE: the choke may not be needed if the engine is warm or the air
temperature is high.
3. Move the throttle level towards the FAST position approximately 1/3 of the way.
4. Depress the clutch pedal and turn the engine switch to START and hold until the
engine starts.
5. Release the key when the engine starts and allow it to return to the ON position.
6. Gradually move the choke lever to the OPEN position as the engine warms.
7. Slowly release foot pedal to engage chipper.
Move machine to a
clear, level area
outdoors before
starting. Do not
operate machine on
a paved, concrete, or
gravel surface. Do
not operate in the
vicinity of
bystanders. Make
sure cutting
chamber is empty
before starting.
Operation
Move machine to a
clear, level area
outdoors before
starting. Do not operate
machine on a paved,
concrete, or gravel
surface. Do not operate
in the vicinity of
bystanders. Make sure
cutting chamber is
empty before starting.
Release the key if the
engine fails to start
within 5 seconds.
Failure to release starter
will overheat and
possible damage the
starter. Wait 10 seconds
before trying again.
Starting Instructions: 13 HP Engine Models
Starting Instructions: 20 HP Engine Models