Echo 74520 Owners Manual v.2 - Manual (Page 12)

Page 8 5" Chipper W/Hyd Feed Owners Manual
2.3 ATTACH THE HITCH
2.4 ATTACH THE CHIPPER CHUTE
2.5 ATTACH THE BLOWER DIS-
CHARGE TUBE
1. Attach the blower discharge tube to the mounting
flange on the chipper frame (See Fig. # 3 & 4). Half of
the mounting clamp is already attached to the tube.
2. Slide the tube into the flange and tighten the bolts to
secure it.
3. Install the second half of the clamp to the tube and
flange.
4. Grease the chute grease zerk to allow free rotation.
Rotate the tube 360 degrees and lock it in place with
the handle to make sure it is mounted correctly.
1. Insert the adjustable hitch into the hitch channel on
the trailer bottom (See Fig. # 3).
2. Insert a 3/8 x 3-1/2" bolt through the bolt hole in the
adjustable hitch.
3. Secure with a washer and nut.
4. Place the jack stand on the side of the hitch and
secure with the snap pin.
1. Mount the chipper chute to the chipper housing using
eight 3/8 x 1-1/2" bolts and locknuts (See Fig. # 3 &
4).
2. Attach the chute extension tray to the extension
chute hinge on the chipper. Use four 3/8" x 1" bolts,
washers, and nuts.
Assembly
Fig. # 4, PTO chipper assembly