Echo 74500 Owners Manual v.2 - Manual (Page 13)

Page 7 Skid Steer Chipper Operator’s Manual
Assembly
MOUNTING THE 4 POSITION VALVE
Attaching the 4 position valve:
1. Place the 4 position valve on the chipper chute over the
(3) pre-drilled mounting holes.
2. From the inside of the chipper chute, using the 5/16” x 3/
4” bolts (P/N 15003), and washers (P/N 15250) thread
the bolts into the 4 position valve
3. Tighten 5/16” hardware to proper torque.
4. Attach the valve control lever according to the diagram
below.
5. Tighten the 5/16” bolt to the proper torque.
Fig. #8, Mounting the four position valve.
Fig. #9, Connecting the valve control lever to the 4 position valve.
(as needed)