Echo CH45342 Owners Manual v.1 - Manual (Page 15)

4.5 INCH CHIPPER
11
ENGLISH
FEATURES & CONTROLS
3.2.1 CHIppER CoNTRoLS
H 1. itch: On CH45390 models, always use 2
inch (50 mm) ball and safety chains.
Jack stand
2. : Always have in uP position
and clear from ground when moving. When
in use, place in DOWN position on a level
surface.
belt guard
3. : never remove guards when
chipper is in use.
Rotor access cover
4. : Remove to expose
chipper blades.
discharge cap
5. : Chipped materials exit
through the discharge cap. a discharge tube
is an available alternative.
Chipper chute
6. : Feed materials to be
chipped through the chipper chute.
Chipper engagement lever
7. : pull lever
up for start position. Push lever down for
chipping position.
3.2 ENGINE modEL CoNTRoLS
2
1
3
4
5
6
7
3.2.2 ENGINE CoNTRoLS
Engine 1. choke: use when starting a cold engine.
push lever to on position when starting. push to oFF
position when engine is running.
Fuel cut-off switch
2. : push lever to the on position to
start and run engine.
Figure 3.2, Honda engine
NoTE
For more detailed engine information, see the engine
owners manual provided with the chipper.
Figure 3.1, briggs & stratton engine
Engine throttle 3. : Changes engine speed. push lever
all the way to the ON position for full throttle operation.
Push the opposite way for engine idle. Push all the way
to the OFF position to shut engine off. Refer to engine
manual for further engine operating instructions.
Starter cord
4. : To start, pull the cord until light resistance
is felt and then pull briskly.
Engine switch
5. : turn to on position to start and run
engine. To stop, turn to OFF position.
Fuel tank
6. : use unleaded gasoline with a pump octane
rating of 86 or higher.