Echo 76624 Instruction v.1 - Manual (Page 2)

Instruction Sheet
PROGRAM SMART SWITCH
Program the smart switch with the chip provided in the kit.
1. Turn the key to power up the machine but do not start
the engine.
2. Remove the plug from the smart switch with a screw
driver or other sharp object.
3. The Smart Switch display should read "Forward Speed
Stopped."
4. Push the down arrow. The display should show current
date and time.
5. Push ESC.
6. Scroll to STOP. Push OK.
7. The display should read "Stop Prg." Scroll to "Yes"
and push OK.
8. Scroll to "Program" and push OK
9. Scroll to "Clear Prg" and push OK.
10. At the prompt to clear program, scroll to "Yes" and
push OK.
11. The next screen will ask for a password. Use the
arrows to enter in "BEAR" (up and down arrows to
choose a letter, right and left arrows to move cursor).
Push OK.
12. The current program will be deleted.
13. Push ESC.
14. Scroll to "Card." Push OK
15. Put the new chip in. Two chips are included in the kit,
one for the gas engine model and one for the diesel
model. Pick the appropriate chip for your machine.
16. Scroll to "Card > ." Push OK.
17. Scroll to "Yes." Push OK.
18. At next prompt, scroll to "Start." Push OK.
19. The display should now read "Forward Feed
Stopped."
20. Take the chip out and put the plug back in.
21. Your machine should now be operational.
CONNECT WIRES
1. Remove switch box cover (see Figure 2).
2. Remove knock outs from the switch box using a screw
driver or hammer. These holes will be used for the
reset/override switch and LED.
3. Connect the red and red/black wires from the extension
tray harness to the reset/override switch provided (for
full electrical schematic, see
Figure 5).
4. Connect the red/yellow and
white wires to the LED as
shown in Figure 3.
5. Connect the remaining three
wires from the electrical harness
to wires in the main switch box,
matching wire colors.
6. Push the LED through the
appropriate hole in the switch
box until it snaps into place.
7. Unscrew the nut and button off
the reset/override button and install it in the appropriate
hole in the switch box. Screw nut and button back on to
secure reset/override button in place on the switch box.
8. Secure switch box cover in original position with
existing hardware.
9. Add the three decals to the switch box cover as shown
in Figure 2.
OPERATION
After the safety bar has been installed, start up the chipper,
engage the feed roller, and check to see if the bar operates
correctly. The feed roller should stop when a minimum of
34 lbs. is applied to the safety bar. Forward feed should
resume when the reset button is pushed.
If a branch causes a false trip of the safety bar during
operation, push in the reset button and hold to override
and reengage the feed roller.
Upon start-up, the red light will be on and the operator must
push the reset button before the feed roller will operate.
WHITE RED/YELLOW
Figure 3. LED wiring
REMOVE PLUG
Figure 4. Chip location in Smart Relay