8 lubrication, 50 h, Important – Echo CH500H Owners Manual v.3 User Manual
Page 19

5" and 8" Skid Steer Chipper
15
SERVICE & MAINTENANCE
BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,
DISENGAGE THE HYDRAULICS AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.
WARNING
5.8 LUBRICATION
Figure 5.8 - Grease every 50 hours
Figure 5.10 - Grease Yearly
Figure 5.4 - Grease every 50 hours
Figure 5.7 - Grease every 50 hours
Figure 5.6 - Grease every 50 hours
Figure 5.9 Same Zerk as Figure 5.4, shown with shield removed.
Figure 5.5 - Grease every 50 hours
Lubricate the machine periodically with a lithium-based
grease. Extreme working conditions will require more
frequent greasing.
Grease the following points every 50 hours of operating
time:
IMPORTANT
Polyurea and lithium-based greases are not
compatible. Mixing the two grease types may lead to
premature failure.
NOTE
Do not over grease bearings. Overfilling can lead to
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
50
h