Echo CH611DH Instruction v.2 - Manual

Instruction Sheet
Instructions
PN 75979-00
Rev.021408
SUBJECT: SNUBBERS WITH
RELAY, KIT # 75983-00
FITS MODELS: 6" CHIPPERS
(CH6670H, CH611DH, CH6993H)
AND 8" TURNTABLE CHIPPERS
(CH8670H, CH8993H)
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables and make sure all moving parts have
come to a complete stop.
WARNING
These instructions describe how to install two
snubber harnesses and a new relay. The relay comes
preprogrammed for the specific model on which it will be
installed.
1. INSTALL SNUBBER HARNESSES
1.1 Locate snubber harnesses in kit (see below).
For 6” chippers: To locate the valve assembly, open the
engine hood. The valve assembly is under the gauge panel
in the engine compartment (see below).
For 8” chippers: To locate the valve assembly, open the
belt cover. The valve assembly is located to the right of
the belt (see below).
1.2 Unplug the connectors on the valve assembly (shown
with arrows below).
1.3 Plug the snubber harnesses into the valve assembly,
and then plug the connectors removed in step 1.2 into the
other end of the snubbers, taking care to replace connectors
into the same side as which they were removed.