Echo CH8670H Owners Manual v.3 - Manual (Page 12)

8 TURNTABLE CHIPPER
ASSEMBLY
2.10 dISchaRGE TubE
Attach the discharge tube to the mounting flange on the 1.
chipper frame. Half of the mounting clamp is already
attached to the tube. Slide the tube onto the flange
and tighten the bolts to secure it.
Install the second half of the clamp to the tube and
2.
flange.
grease the zerk and tighten the nuts completely.
3.
loosen each nut one turn and attempt to rotate the 4.
tube. If it does not rotate freely, loosen each nut 1/2
turn until it rotates freely.
rotate the tube 360 degrees and lock it in place with
5.
the handle to make sure it is mounted correctly.
keep nuts as tight as possible while allowing the
discharge tube to freely turn.
NoTE
SECOND
HALF OF CLAMP
ZERK
Figure 2.3 - Discharge Tube Assembly
Figure 2.2 - Chute Extension Tray Assembly.
hairpin Clip
Feed Control
lever
Chipper
Chute
Extension
hinge
Extension
Tray
Position this lip
behind the lip
on the chipper
chute shown
below. hold
the extension
tray directly
above the
chipper chute
and slide it
downward.
2.9 chuTE EXTENSIoN TRaY
After mounting the chipper chute to the chipper 1.
housing, slide the chute extension tray over the chipper
chute as shown in Figure 2.2.
Align the five bolt holes in the chute extension tray with
2.
the bolt holes in the extension hinge.
Insert a 3/8" x 1" carriage bolt (included in owner's
3.
kit) through the two outside holes on the extension
tray and the extension hinge. Secure the bolts with
washers and nuts.
Insert one 3/8" x 1" carriage bolt through the end of the
4.
chute support and middle holes on the extension hinge
and extension tray. Secure the bolts with washer and
nuts. secure with hairpin clips.
Make sure that you position the lip on the extension
tray behind the lip on the chipper chute. This provides
a flatter surface and prevents obstructions while feed-
ing the machine.
NoTE