Service & maintenance, 1 maintenance schedule, Warning – Echo CH911DH Owners Manual v.4 User Manual
Page 17: Englis h, Service and maintenance schedule
9 INCH CHIPPER
13
englis
H
Section
serviCe & mainTenanCe
5
Warning
To prevent personal injury or property damage, shut
off engine and make sure all moving parts have
come to a complete stop before servicing, adjusting
or repairing.
5.1 mainTenanCe sCHeDule
The items listed in this service and maintenance schedule
are to be checked, and if necessary, corrective action
taken. This schedule is designed for units operating under
normal conditions. If the unit is operating in adverse or
severe conditions, it may be necessary for the items to be
checked and serviced more frequently.
see engine oWner’s manual for furTHer
engine mainTenanCe anD TroublesHooTing
informaTion.
serviCe anD mainTenanCe sCHeDule
freQuenCY
ComPonenT
mainTenanCe
reQuireD
refer To
engine
oPeraTor’s
manual
before
eaCH
use
everY
8
Hours
everY
25
Hours
everY
50
Hours
everY
200
Hours
everY
Year
AIR CLEANER
CHECk AND ClEAN (1)
AIR INTAKE
ClEAN (1)
ENgINE OIl
CHANgE (1)
FUEL FILTER
REPLACE
SPARk Plug
CHECk CONDITION AND gAP
HyDRAulIC OIl
CHECk/FIll
ENgINE OIl
CHECk/FIll
FUEL TANK
CHECk/FIll
ALL INTERNAL AND
EXTERNAl NuTS AND
BOLTS
CHECk TIgHTNESS
TIRE PRESSURE
CHECk
BATTERY CONNECTIONS
CHECk
CHIPPER ANVIl
CHECk ClEARANCE AND RE-
TORQuE TO 75 FT-lBS. (2)
CHIPPER BlADES
CHECk SHARPNESS AND RE-
TORQuE TO 120 FT-lBS. (2)
ENTIRE MACHINE
CLEAN
DRIVE BELT
CHECk
HyDRAulIC DRIVE BElT
CHECk
BELT TENSION
CHECk
BElT/PullEy AlIgNMENT
CHECk
gREASE ZERkS
LUBE
HyDRAulIC OIl FIlTER
REPLACE
WHEEl BEARINgS
CHECk AND REPACk
(1) PERFORM MORE FREQuENTly uNDER EXTREMEly DuSTy CONDITIONS.
(2) PERFORM MORE FREQuENTly WHEN CHIPPINg DRy OR DIRTy WOOD.
as the limited Warranty states, failure by the owner to perform normal maintenance will void the machine’s warranty. The aggressive,
high-speed nature of chipping reQuires THe oWner To Perform THe above lisTeD normal mainTenanCe. special consideration
to maintain and re-torque the CHiPPer anvil, CHiPPer blaDes, anD all inTernal anD exTernal nuTs anD bolTs is the sole
responsibility of the owner. failure by the owner to do so shall be cause for denial of warranty.