Echo 76854 - Manual (Page 10)

PTO CHIPPERS 6
Section
2.1 aTTaCH CHuTe - CH8540
assemBlY
1. Remove chipper from shipping crate. Place unit on a level surface before assembling. See the Torque chart in
Section 7 for the recommended torque for tightening bolts and screws.
2. Mount the chipper chute to the frame mounting bracket using eight 3/8 x 1-1/2" bolts and locknuts. use three bolts
on each side and two on the bottom.
3. For models with extension trays: Attach the extension tray to the chute with five 3/8 x 1" bolts and nuts.
2
2.2 aTTaCH CHuTe - HYDraulIC FeeD moDels wITH saFeTY Bar
1. Remove chipper from shipping
crate. Place unit on a level
surface before assembling.
See the Torque chart in
Section 7 for the recommended
torque for tightening bolts and
screws.
2. Attach the chute support to the
front side of the chipper base
with one 3/8 x 1" hex bolt,
washer and nut.
3. Attach the chipper chute to
the feed roller with eight 3/8 x
1-1/2" carriage bolts, washers,
and nuts. Thread the bolts from
inside the chute.
4. Attach the chute support to the chute through the
middle hole on the extension tray hinge using
existing hardware.
5. connect the three wires coming from the feed chute
to the connectors that are located underneath the
feed roller, matching ziptie colors.
6. Plug the safety bar wire harness into the matching
color plugs on the chipper frame.
Figure 2.1. Figure 2.2.
Figure 2.3