IOGear GUWAVKIT4 For Windows - Manual (Page 6)

6
Overview
Prepare to Software Installation - Windows
Receiver Base Front View
1. Power / Signal
Indicator Light
2. Wireless Connection
LED Light
Receiver Base Back View
1. DC Power Input
2. HD Port
3. D-Sub 15Pin (VGA)
4. 3.5mm Audio Out
5. USB 2.0 Port
6. Antenna PC Adapter
1. USB 2.0
If your PC contains a previous IOGEAR Wireless Software or other Wireless USB
driver installation, please perform a proper uninstall procedure using the Windows
Control Panel.
Prior to Software Installation:
1. It is important to make sure there is no prior installation of Wireless USB or Display Link
software from IOGEAR or other com¬panies. IF YOU HAVE THIS SOFTWARE IN YOUR
SYSTEM, THIS WILL CAUSE THE IOGEAR WIRELESS SOFTWARE NOT TO WORK
PROPERLY.
2. Go to Control Panel>Programs and Features and look through your programs to ensure
you do not see any UWB wireless programs.
3. If you see any UWB wireless programs listed under program name, uninstall it by
highlighting and clicking on the Uninstall tab.
4. The installation software requires .NET Framework version 2.0 (or later) to be installed on
the computer. In case it is not installed it may be downloaded from the following location:
http://www.microsoft.com/downloads/details.aspx?FamilyID=0856EACB-4362-4B0D-
8EDD-AAB15C5E04F5&displaylang=en
5. Anti Virus software set to very high security may prevent the installer from running. It is
recommended to temporarily disable the Anti viruses SW during the installation.
1 1 1 2 3 4 6 5 2