IOGear GBGPS201 - Manual (Page 11)

Operation
8
Once you establish connection with your Bluetooth
device, the blue LED will remain solid blue.
Note: If you encounter any connectivity problems, please
consult User Manual for advanced troubleshooting.
Step 3: Connect GPS Receiver to your Bluetooth-enabled
device
In order to connect the IOGEAR GPS receiver to your Bluetooth-
enabled device, you will have to establish a Serial Port connection
between the two devices. The instructions below are to demonstrate
an example on how this is setup; this will probably vary depending
on your equipment and the Bluetooth software version that you are
using.
If you have any problems establishing the connection between the
GPS receiver and your Bluetooth device, please consult the manual
of your Bluetooth device. Also, for more detailed instructions,
consult the User manual of your IOGEAR Bluetooth GPS unit.
Connect GPS Receiver to your PDA
Check List
Complete the following checklist before beginning operation:
• Navigation software application and maps are
correctly installed on your PDA.
• Bluetooth GPS battery is fully charged
• PDA battery is fully charged, if not directly
connected to a power outlet
• Verify that Bluetooth functionality is enabled and
working on your PDA.