JLG G12-55A Parts Manual User Manual
Page 38
BOOM
G10-55A, G12-55A
31200728
2-14
PAL6400
54
65
66
3
110
117
201
82
78
135
201
110
117
201
78
146
201
110
136
201
82
127
66
65
58
100
138
139
201
78
137
201
99
66
60
55
113
112
201
82
96
141
143
201
3
48
66
65
54
100
138
139
201
99
63
60
53
68
201
98
111
142
201
99
99
87
44
63
60
51
50
7
86
86
115
201
115
201
121
201
122
122
G12-55A
Note:
Wear Pad Shimming:
Whenever a shim is used with a pad, a spacer with holes must be inserted between pad & shim.
The wear pad or wear pad insert must not sit directly on the slotted surface of shims.
Add wear pad shims & spacers as required to shim boom to maintain a total minimum gap of 0.070 to 0.130 in (1,8 to 3,3 mm) in
both horizontal & vertical directions.
Wear pad bolts require one hardened washer. However, up to (2) hardened washers may be used except where noted otherwise.
Under no circumstances should more than (2) hardened washers ever be used.
The length of pad bolts depends on the number of the shims used. The bolt cannot extend past chamfer on wear pad.
Add Mystik Tetrimoly Grease (14404793) to all wear pads & all wear pad slide pathways. If applicable, this includes all pad grease
fittings at the rear of boom.