Fork mounted hook, Fork mounted hook -31 – JLG G12-55A Operator Manual User Manual
Page 103
Section 5 - Attachments
5-31
31200745
Fork Mounted Hook
Use Appropriate Carriage Attachment Capacity Chart
To determine maximum capacity, refer to “Telehandler/
Attachment/Fork Capacity” on page 5-4.
Suspend loads in accordance with requirements set forth in Section
1 - General Safety Practices.
The joystick (1) controls lift/lower and extend/retract movement of the boom.
The tilt switch (2) controls fork tilt.
• Press left side of switch to tilt up.
• Press right side of switch to tilt down.
Installation Procedure:
• Ensure carriage is properly installed. Refer to “Attachment Installation” on
• Secure the fork mounted hook to the forks by sliding the fork mounted hook onto
the parent forks and install the retaining pin behind the vertical shank of the fork.
OY0640
OY2920
1
2