JLG G6-23A Operator Manual - Manual (Page 31)

Section 2 - Pre-Operation and Inspection
2-7 31200192
3. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
4. Worklights (if equipped) - Clean, undamaged and work properly.
5. Cab & Electrical -
• General appearance; no visible damage.
• Window glass undamaged and clean.
• Gauges, switches, joystick, foot controls, park brake & horn operational.
• Check seat belt for damage, replace belt if frayed or cut webbing, damaged
buckles or loose mounting hardware.
6. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
7. Rear Axle - Steer cylinders undamaged, not leaking; pivot pins secure;
hydraulic hoses undamaged, not leaking.
8. Main Control Valve - See Inspection Note.
9. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
10. Engine Compartment -
• Drive belts, check condition & replace as required.
• Air cleaner element condition indicator, check for clogged condition. Replace
element as required.
• Check and clean Pre-Cleaner as required.
• Battery cables tight, no visible damage or corrosion.
• Engine cover properly secured and latched.
11. Mirrors - Clean and undamaged.
12. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
13. Attachment - Properly installed, see “Attachment Installation” on page 5-7.