JLG 40H Service Manual - Manual (Page 11)

SECTION 1 - SPECIFICATIONS
3120240 – JLG Lift –
1-3
10 Microns Nominal.
1.3 PERFORMANCE DATA.
Travel Speed.
2WD- 4.5 MPH (7.2 KM/HR).
4WD - 4.0 MPH (6.4 KM/HR).
Gradeability.
2WD- 25% or 14°slope, hard surface.
4WD - 40% or 22°slope, hard surface.
Turning Radius.
2WS/2WD- 16 ft. 6 in. (5.1 m).
2WS/4WD - 16 ft. 6 in. (5.1 m).
Boom Speed Lift.
Up 25 - 40 Seconds.
Down 20 - 30 Seconds.
Telescope Speed.
Extend 50 - 80 Seconds.
Retract 40 - 60 Seconds.
Swing Speed 360°.
Left 61 - 92 Seconds.
Right 61 - 92 Seconds.
Boom Elevation.
+74° (above horizontal).
-22° (below horizontal).
Model 40H+6.
74° +15° ART. (above horizontal)
-22° -80° ART. (below horizontal)
Machine Weight.
Model 40H (2WD) - 11,600 LBS. (5,266 KG.).
Model 40H (4WD) - 12,000 LBS. (5,448 KG.).
Model 40H+6 - 13,350 LBS. (6,005 KG.).
Machine Stowed Height.
Model 40H (2WD) - 7 ft., 10 in. (2.39 M).
Model 40H (4WD) - 7 ft., 10 in. (2.39 M).
Machine Stowed Length.
Model 40H (2WD) - 25 ft.,2 in. (7.67 M).
Model 40H (4WD) - 25 ft.,2 in. (7.67 M).
Model 40H+6 (4WD) - 26 ft., 10 in. (8.18 M).
Machine Width.
Model 40H/40H+6(2WD/4WD) - 7 ft.,11 in. (2.41 M).
Wheelbase.
Model 40H/40H+6 (2WD/4WD) - 92 in. (2.34 M).
1.4 TORQUE REQUIREMENTS.
NOTE: *Retorque after first 200 hours of operation and
every 500 hours thereafter.
NOTE: See Procedure Section for tightening sequence of
turntable bearing bolts.
NOTE: When maintenance becomes necessary or a fas-
tener has loosened, refer to the Torque Chart to
determine proper torque value.
1.5 LUBRICATION.
Ford LSG423/LRG423/LRG425 Engine.
Single Viscosity Oils (SF, SF-SE, SF-CC, SF-CD).
Description To r q u e
Value (Dry) I n t e r -
v a l
Hours
A. Bearing To Chas-
sis 110 lbs.
(149 Nm) *200/500
B. Bearing To Turn-
table 220 lbs.
(298 Nm) *200/500
C. Wheel Lugs 90 lbs.
(122 Nm) 100
D. Drive Hub 150 lbs.
(204 Nm) *200/500
E. Swing Hub 110 lbs.
(149 Nm) *200/500
When Outside Temp is
Consistently Use SAE
Viscosity Number