JLG 3246E2 Parts Manual - Manual (Page 94)

3-24 3120856
SECTION 3 SCISSOR ARMS
S
E
C
T
I
O
N
3
S
C
I
S
S
O
R
A
R
M
S
39 3311501 Nut 5/16”-18NC 8
40 3311501 Nut 5/16”-18NC 8
41 3311605 Locknut 3/8”-16NC 4
42 3422641 Pin, Pivot 2
43 3422642 Pin, Headed (Top) 2
44 Pin, Pivot Options: 12
3422773 Prior to S/N 82160
3422882 S/N 82160 to Present
45 Pin, Headed (Bottom) Options: 2
3422742 Prior to S/N 82160
3422862 S/N 82160 to Present
46 3422746 Pin, Pivot 10
47 Pin, Pivot (Special Pins) Options: 6
3422759 Prior to S/N 82160
3422863 S/N 82160 to Present
48 Hardware Options: A/R
48A 3440418 Rollpin (Prior to S/N 82160) 2
48B 3760348 Ring, Retaining (S/N 82160 to Present) 20
49 3450405 Pin, Cotter 1/8” x 1 1/4” A/R
50 3450804 Pin, Cotter 1/4” x 1” 2
51 3760387 Ring, Retaining 10
52 3841344 Rod, Retaining 2
53 Roller Options: 2
3860078 Prior to S/N 82160
3860092 S/N 82160 to Present
54 3900329 Screw #8-32NC x 1 1/2” 2
55 4240125 Strap, Nylon 4
56 4240128 Strap, Safety Prop 1
57 4360548 Switch, Limit (was p/n 4360321) 1
58 4420062 Tape, UHMW .38ft/
11.6cm
59 Connector, Strain Relief Options: 2
Use 4460662 1/2” Pipe Threads (Was P/N 4460049)
4460662 1/2” Pipe Threads (Used on Limit Switch p/n 4360321)
4460968 M20-1.5 (Used on Limit Switch p/n 4360578)
60 to 62 Not Used
63 4711400 Flatwasher 1/4” Narrow A/R
64 4740307 Washer, Thrust 8
65 4740438 Washer, Special 10
66 4750800 Flatwasher #8 2
67 Not Used
68 4760800 Lockwasher #8 2
69 4845981 Prop, Safety 1
70 Harness, Lift Down Options
(Not Shown - See Section 7 for Breakdown): 1
4922088 Standard Controls Machines (Lower)
4922089 Standard Controls Machines (Upper)
4922301 Proportional Control Machines
— — — — — —
FIGURE 3-6. SCISSOR ARMS INSTALLATION - 3246E2 (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.