Daily walk-around inspection points, Sheet 3 of 3 -13 – JLG 660SJ Operator Manual User Manual
Page 36
SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-14
– JLG Lift –
3121205
33. Battery - Proper electrolyte levels; cables tight, no vis-
ible damage or corrosion.
34. Engine Oil Supply - Full mark on dipstick; filler cap
secure.
35. Muffler and Exhaust System - See Note.
36. Hydraulic Pump - See Note.
37. Engine Tray Pivot - See Note.
38. Hydraulic Oil Medium Pressure Filter Housing - Hous-
ing secure.
39. Hydraulic Swivel - See Note.
40. Horizontal Cutoff Limit Switch - (High Engine/High
Drive Cut-off Switch) Arm free to move, and free from
dirt and grease.
41. LP Gas Tank (If Equipped) - See Note.
42. Flow Valves - See Note.
43. Frame - See Note.
44. Main Boom Sections - Wear pads secure. All cylinders
- rod end shafts and barrel-end shafts properly
secured; evidence of proper lubrication.
45. Platform Pivot Pin - See Note.
Figure 2-6. Daily Walk-Around Inspection Points - Sheet 3 of 3