Bernina Sergers - Manual (Page 108)

Mastering
Your
BERNINA ®
BERNINA ® Sergers
M
ASTERING
Y
OUR
BERNINA ® S
ERGER
2/15/03 108
Notes
©2003 BERNINA® of America, Inc. Permission to copy granted only to Authorized BERNINA ® Dealers
Multi-Purpose Foot -
Attaching Pre-Strung Beads
Following the instructions in your owner’s manual, thread the serger for
a narrow 3-thread flatlock stitch using the right needle. Adjust settings
as indicated.
Set stitch length to 4mm.
Attach the Multi-Purpose Foot (no guide), following the directions in the
instruction leaflet for the Multi-Purpose Foot with Guide.
Lay the pre-strung beads in the groove on the top of the foot, threading
them under the back groove (see instruction leaflet for the Multi-Pur-
pose Foot with Guide). Turn the handwheel to encase the first beads
inside the thread chain.
Fold the fabric in half to 2” x 6” and place the fabric under the foot with
the fold halfway between the needle and the stitch finger or against the
right seam guide.
Slowly flatlock the beads to the folded fabric.
Gently pull the fabric flat.
Mount the sample.
Fabric ................................................................... mediumweight, 4” x 8”
Other ................................. 10” length of 4mm, plastic, pre-strung beads
Needle ............................................................................. 80/12 Universal
Thread ................................................................... 3 cones serger thread
Presser Foot ........................................... Multi-Purpose Foot with Guide
Stitch ............................................ narrow 3-thread flatlock (right needle)