JLG 1250AJP Parts Manual User Manual
Page 62
2-4
SECTION 2 TURNTABLE
FIGURE 2-1. VALVE, BATTERY, HORN & AUXILIARY PUMP INSTALLATIONS
ITEM #
PART NUMBER
QTY.
DESCRIPTION
REV.
0273377
Ref.
VALVES INSTALLATION - TURNTABLE MOUNTED
L
1
0100011
A/R
Compound, Locking
2
0140001
1
Horn
3
0641406
5
Bolt 1/4”-20NC x 3/4”
4
Not Used
5
0641408
2
Bolt 1/4”-20NC x 1”
6 to 8
Not Used
9
0641608
8
Bolt 3/8"-16NC x 1"
10
Not Used
11
0902800
1
Bracket, Module Mounting
12
1320322
1
Clamp
13
Not Used
14
Use 1001112757
1
Module, B.L.A.M. (Note: Control System must be recalibrated
when Module is replaced) (was p/n 1600332 prior to S/N
0300141570)
2915024
1
Update Kit (Includes Cables, Programming Instructions & CD
Software)
15
3300454
4
Nut, Special
16 to 26
Not Used
27
1
Main Valve Assembly Options (See Figure 2-2 for Breakdown):
Use 1001103793
Prior to S/N 0300119708 (was p/n 4641304)
Use 1001103793
S/N 0300119708 to S/N 0300128768 (was p/n 1001099515)
1001103793
S/N 0300128768 to Present
28
4711400
5
Flatwasher 1/4” Thin
29
Not Used
30
4711600
12
Flatwasher 3/8" Thin
31
Not Used
32
4791400
1
Starwasher 1/4”
33
Not Used
34
0641620
2
Bolt 3/8"-16NC x 2 1/2”
35
0641636
2
Bolt 3/8"-16NC x 4 1/2”
36
3380523
1
Shield, Tube
37
3
Enable Valve Assembly Options:
See Note
Prior to S/N 0300131893 (was p/n 4641306, 4641381 &
4641391)
Ref.
NOTE: The above listed enable valves & any associated
service parts are no longer available for service. Verify
stamping on valve block. If valve is JLG P/N 4641306
(valve block stamped with P/N CP12673), JLG P/N
4641381 (valve block stamped with P/N HA1022) or JLG
P/N 4641391 (valve block stamped with P/N HA60220) you
must replace all 3 enable valves with JLG P/N
1001106391. If your machine is already equipped with
JLG P/N 1001106391(valve block stamped with P/N
HF46525-08) valves can then be replaced on an as
required basis.
1001112850
S/N 0300131893 to Present (was p/n 1001106391)
7024890
1
Coil