JLG 260MRT Parts Manual - Manual (Page 73)

3121802 260MRT 3-3
SECTION 3 SCISSORS ARMS
FIGURE 3-1. SCISSOR ARMS INSTALLATION
ITEM # PART NUMBER QTY. DESCRIPTION REV.
Ref. SCISSOR ARMS INSTALLATION
Ref. Standard Machines
0259865 Ref. Prior to S/N 0200112688 (Without Load Sense Harness) J
0273069 Ref. S/N 0200112688 to Present (Without Load Sense Harness) B
1001110710 Ref. S/N 0200193881 to Present (With Load Sense Harness) A
Ref. Machines with Level at 6° Slope (Optional on Australian Spec
Only):
1001118678 Ref. Without Load Sense Harness (No Longer Available after
S/N 0200203530) A
1001118680 Ref. With Load Sense Harness A
1 0200699 1 Arm Weldment (1st Inboard)
2 0200700 1 Arm Weldment (1st Outboard)
3 0200701 1 Arm Weldment (2nd Inboard)
4 0200680 2 Arm Weldment (2nd Outboard)
5 0200702 1 Arm Weldment (3rd Inboard)
6 0200682 2 Arm Weldment (3rd Outboard)
7 1 Arm Weldment (4th Inboard) Options:
0200703 Prior to S/N 0200112688
0200728 S/N 0200112688 to Present
8 1 Arm Weldment (4th Outboard) Options:
0200704 Prior to S/N 0200112688
0200729 S/N 0200112688 to Present
9 1683887 1 Lift Cylinder Assembly (See Section 5 for Breakdown)
10 Not Used
11 0100011 A/R Compound, Locking
12 Not Used
13 0641508 2 Bolt 5/16in-18NC x 1in
14 0641510 16 Bolt 5/16in-18NC x 1-1/4in
15 0681524 2 Bolt 5/16in-18NC x 3in
16 0641620 8 Bolt 3/8in-16NC x 2-1/2in
17 0641622 2 Bolt 3/8in-16NC x 2-3/4in
18 0641638 12 Bolt 3/8in-16NC x 4-3/4in
19 0681610 2 Bolt 3/8in-16NC x 1-1/4in
20 0962220 36 Bearing, Garmax
21 0440241 8 Bearing, Polygon
22 A/R Bearing, Garmax Options:
22A 0962234 4 Prior to S/N 0200105000
22B 0962220 4 S/N 0200105000 to S/N 0200112688
22C 0440250 4 S/N 0200112688 to Present
23 to 24 Not Used
25 3311505 20 Locknut 5/16in-18NC
26 3311605 22 Locknut 3/8in-16NC
27 Not Used
28 3340879 2 Pad, Slide Block
29 16 Pad, Arm
3340866 Standard Machine
0940135 Machine with Level at 6° Slope (Australian Spec Option)
30 3422709 2 Pin, Bottom Slider