JLG 260MRT Parts Manual - Manual (Page 33)

3121802 260MRT 1-27
SECTION 1 FRAME
FIGURE 1-8. LEVELING JACKS AUTO LEVEL INSTALLATION (AUSTRALIAN SPEC S/N
0200128985 TO PRESENT & CE SPEC S/N 0200141689 TO PRESENT)
ITEM # PART NUMBER QTY. DESCRIPTION REV.
Ref. LEVELING JACKS AUTO LEVELING INSTALLATION
0273848 Ref. All Machines except Machines with Level at 6° Slope G
1001118676 Ref. Machines with Level at 6° Slope (Australian Spec Option) A
1 0100011 A/R Compound, Locking
2 0641407 A/R Bolt 1/4in-20NC x 7/8in
3 0641508 20 Bolt 5/16in-18NC x 1in
4 0641816 2 Bolt 1/2in-13NC x 2in
5 0641824 8 Bolt 1/2in-13NC x 3in
6 4 Cover Options:
1671195 Cover - 26in/66.5cm H (All Machines except Machines with
Level at 6° Slope)
1671165 Cover - 31.75in/80.6cm H (Machines with Level at 6° Slope
Software) (Australian Spec Option)
7 1701214 8 Decal - Legend
8 2080053 20 Fastener 5/16in-18NC
9 Not Used
10 3300454 16 Nut 1/4in-20NC
11 3310805 8 Locknut #8-32NC
12 3 Locknut Options:
3311405 Locknut 1/4in-20NC
3311605 Locknut 3/8in-16NC
13 3311805 10 Locknut 1/2in-13NC
14 3572384 1 Plate, Front Cover
15 3572385 1 Plate, Rear Cover
16 3572388 1 Plate, Top Cover
17 3930820 8 Bolt #8-32NC x 1-1/4in
18 2 Leveling Jack Assembly Options (See 101 to 115 for
Breakdown):
4210017 (All Machines except Machines with Level at 6° Slope
Software)
4210011 (Machines with Level at 6° Slope) (Australian Spec Option)
19 4340886 1 Mount, Valve
20 4420039 6ft/1.8m Tape, Non-Skid
21 8ft/2.4m Tape, Safety Options:
Use 4420051 S/N 0200128985 to S/N 0200149768 (was p/n 4420052)
4420051 S/N 0200149768 to Present
22 4641374 1 Leveling Jack Control Valve Assembly (See 201 to 207 for
Breakdown)
23 4711400 A/R Flatwasher 1/4in Thin
24 4711500 20 Flatwasher 5/16in Thin
25 4711800 20 Flatwasher 1/2in Thin
26 4750800 8 Flatwasher #8 Regular
27 4922748 1 Harness - Leveling Jack (Not Shown - See Section 7 for
Breakdown)
28 3572324 2 Cover, Rear Axle
29 3572326 1 Cover, Center Frame
30 1704786 4 Decal - Max Load
31 0641608 3 Bolt 3/8in-16NC x 1in (S/N 0200155061 to Present)