JLG 600A_AJ Operator Manual - Manual (Page 101)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121615 – JLG Lift – 6-1
SECTION 6. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.1 INTRODUCTION
This section of the manual provides additional necessary infor-
mation to the operator for proper operation and maintenance of
this machine.
The maintenance portion of this section is intended as informa-
tion to assist the machine operator to perform daily maintenance
tasks only, and does not replace the more thorough Preventive
Maintenance and Inspection Schedule included in the Service
and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual - Global Spec
(s/n 0300177361 to Present)....................................................3121616
Illustrated Parts Manual - Global Spec
(s/n 0300177361 to Present)....................................................3121617
6.2 OPERATING SPECIFICATIONS
Table 6-1. Operating Specifications
Maximum Work Load (Capacity) - ANSI
Unrestricted:
Restricted:
500 lb (227 kg)
1000 lb (454 kg)
Maximum Work Load (Capacity) - CE &
Australia
Unrestricted:
Restricted:
500 lb (230 kg)
1000 lb (450 kg)
Maximum Travel Grade (Gradeability)
2WD
4WD
30%
45%
Maximum Travel Grade (Side Slope) 5°
Turning Radius - (outside)
2WS
4WS
17 ft. 8 in. (5.38 m)
11 ft. 8 in. (3.56 m)
Turning Radius - (outside) narrow chassis
2WS
4WS 16 ft. 6 in. (5.03 m)
11 ft. 2 in. (3.4 m)
Turning Radius - (inside)
2WS
4WS
11 ft. 5 in. (3.48 m)
5 ft. 6 in. (1.68 m)