JLG 500RTS Operator Manual User Manual
Models, Operation & safety manual
This manual is related to the following products:
Table of contents
Document Outline
- Operation & Safety Manual
- Foreword
- Section 1. Safety Precautions
- Section 2. Machine Preparation and Inspection
- 2.1 General
- 2.2 Preparation For Use
- 2.3 Delivery and Periodic Inspection
- Handrail Assemblies
- Platform Assembly
- Sizzor Arms
- Electrical Cable
- Pivot Pins
- Lift Cylinder
- Frame
- Drive Hubs
- Tire and Wheel Assemblies
- Sliding Wear Pad Blocks
- Hydraulic Oil Supply
- Steer Cylinder
- Steer Linkage
- Steer Spindle Assemblies
- Control Boxes (Console and Ground)
- Battery
- Engine
- Hydraulic Pump and Valves
- Platform Placards
- Lock-Out Cylinders (If Equipped)
- Leveling Jacks (If Equipped)
- Traversing Platform (If Equipped)
- 2.4 Daily Walk-Around Inspection
- 2.5 Daily Functional Check
- 2.6 Lockout Cylinder Check (If Equipped)
- 2.7 Dual Fuel System
- 2.8 Torque Requirements
- Section 3. User Responsibilities and Machine Control
- Section 4. Machine Operation
- Section 5. Emergency Procedures
- 5.1 General
- 5.2 Emergency Towing Procedures
- 5.3 Emergency Controls and Their Locations
- Emergency Stop Switch
- Ground Control Station
- Manual Descent (Engine/Pump Failure - Platform Controls)
- Manual Descent (Engine/Pump Failure - Ground Controls)
- Manual Descent (Complete Loss of Power)
- Auxiliary Power (If Equipped) (Engine/Pump Failure - Platform Controls)
- Auxiliary Power (If Equipped) (Engine/Pump Failure - Ground Controls)
- 5.4 Emergency Operation
- 5.5 Incident Notification
- Section 6. Inspection and Repair Log