JLG 400CRT ANSI Operator Manual User Manual

Model, Operation & safety manual

This manual is related to the following products:

330CRT ANSI Operator Manual

Table of contents

Document Outline

FOREWORD
SAFETY ALERT SYMBOLS AND SAFETY SIGNAL WORDS
REVISION LOG
Section 1. SAFETY PRECAUTIONS
1.1 General
1.2 Pre-operation
- Operator Training and Knowledge
- Workplace Inspection
- Machine Inspection
1.3 Operation
- General
- Trip and Fall Hazards
- Electrocution Hazards
- Tipping Hazards
- Crushing and Collision Hazards
1.4 Towing, Lifting, and Hauling
1.5 Additional Hazards / Safety
Section 2. Preparation and Inspection
- 2.1 General
- 2.2 Preparation for Use
- 2.3 Delivery and Periodic Inspection
- 2.4 Daily Walk-Around Inspection
- 2.5 Daily Functional Check
- 2.6 Torque Requirements
- 2.7 Dual Fuel System
Section 3. user responsibilities and machine control
- 3.1 General
- 3.2 Personnel Training
- 3.3 Operating Characteristics and Limitations
- 3.4 Controls and Indicators
  - Ground Control Station
- 3.5 Platform Control Station
Section 4. machine operation
- 4.1 Description
- 4.2 General
- 4.3 Engine Operation
- 4.4 Raising and Lowering
- 4.5 Steering
- 4.6 Traveling
  - Traveling Forward
  - Traveling in Reverse
- 4.7 Parking and Stowing
- 4.8 Platform Loading
- 4.9 Safety Prop
- 4.10 Tie Down/Lift Lugs
  - Lifting
- 4.11 Towing
Section 5. Emergency Procedures
- 5.1 General
- 5.2 Emergency Towing Procedures
- 5.3 Emergency Controls and Their Locations
- Emergency Stop Switch
- Ground Control Station
- Manual Descent
  - 5.4 Emergency Operation
- Operator Unable to Control Machine
- Platform Caught Overhead
- Righting of Tipped Machine
- Post-Incident Inspection
  - 5.5 Incident Notification
  - Table 6-1. Inspection and Repair Log
Corporate Office
JLG Industries, Inc.
1 JLG Drive
McConnellsburg PA. 17233-9533
USA
Phone: (717) 485-5161
Fax: (717) 485-6417