JLG 1200SJP Operator Manual - Manual (Page 51)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121141 – JLG Lift – 3-11
6. Main Telescope
This control allows extension and retraction of the main
boom.
7. Lights (If Equipped)
This switch operates accessory light packages if the machine
is so equipped.
8. Jib Lift
Push forward to lift up, pull back to lift down. Variable lift
speed is using the Function Speed Control.
9. Soft Touch Override Switch (If equipped)
This switch enables the functions that were cut out by the
Soft Touch system to operate again at creep speed, allowing
the operator to move the platform away from the obstacle
that caused the shutdown situation.
NOTE: The Jib Swing function is not operable when the Capacity Select
control is in the 1000 lb. (454 kg for ANSI markets and 450 kg
for CE and Australia markets) position.
10. Jib Swing
This switch allows the operator to rotate the jib to the left or
right.
11. Axle Extend/Retract
This switch allows the operator to extend or retract the axles.
The axles can only be extended or retracted while the
machine is being driven forward or reverse.
12. Soft Touch Indicator (If Equipped)
Indicates the Soft Touch bumper is against an object. All
controls are cut out until the override button is pushed, at
which time controls are active in the Creep Mode.
13. Platform Rotate
This switch allows the operator to rotate the basket to the
left or right.