IKA MS 3 digital - Manual (Page 10)

10 032007
• Unpack
- Please unpack the device carefully
- In the case of any damage a fact report must be set
immediately (post, rail or forwarder)
• Delivery scope
MS 3 basic MS 3 digital
- Shaker MS 3 basic - Shaker MS 3 digital
- Power supply - Power supply
- Standard attachment MS 3.1 - Standard attachment MS 3.1
- Universal attachment MS 3.3 - Universal attachment MS 3.3
- One-hand insert MS 1.21
- One-hand insert MS 1.21
- Operating instructions - Microtiter attachment MS 3.4
- Test tube insert MS 1.32
- Operating instructions
• Use
For mixing liquids
- Touch mode for single test tubes
- Continuous mode for single or several vessels
• Range of use
- Laboratories - Schools
- Pharmacies
This device is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply network that also
supplies residential areas.
The protection for the user is not ensured no more, if the equipment with acces-
sories is operated, which are supplied or are not recommended not by the manu-
facturer or if the equipment in not correct use is operated against the manu-
facturer default.
Unpack Correct use
Commissioning
Power
0 0 0
Switching on
Start
Stop Change to
continuous
operation
Mode A
Operating mode
"Continuous operation"
Speed upto 1300 rpm
C
Mode A
Operating mode
"Touch operation"
Speed upto 3000 rpm
B
1
Setting timer /
0 0 5
100 101
Seconds mode
C
2
Position the rotating knob at the
left stop before starting up
M
(= Factory setting)
The value previously set
w
If these conditions are met, the
unit is ready for service when the
mains plug has been plugged in
Setting Operating modes
Modus A Modus B
(with speed (without speed
limiter) limiter)
Touch mode
(with standard- max. 3000 rpm max. 3000 rpm
attachment MS 3.1)
Continuous mode
(with all max. 1300 rpm max. 3000 rpm
attachments)
Display Action