IKA T 10 basic ULTRA-TURRAX - Manual (Page 18)

18
T 10 basic_092012
Speed table
Note: The speed table was calculated on the basis of a dispersion
volume of 5 ml water using the dispersing tool S 10 N - 5 G.
With other combinations (dispersion tools; medium quantity and
medium viscosity) can result other number of revolutions values.
Adjusting wheel
scale 1 2 3 4 5 6
No-load speed 8.000 9.500 11.500 14.500 20.500 30.000
Speed with
5 ml water 7.900 9.400 11.400 14.450 20.450 29.900
The speeds depend on the dispersing element used as well as the
viscosity and quantity of the medium. Therefore it may change
over the course of a dispersing process if the viscosity of the liquid
changes.
Permitted dispersion tools
Designation Material of shank
S 10 N - 5 G Stainless steel
S 10 N - 8 G Stainless steel
S 10 N - 10 G Stainless steel
S 10 D - 7 G - KS - 65 Synthetic material
S 10 D - 7 G - KS - 110 Synthetic material
Only use the dispersing tools listed in the table and note
the according operating instructions of the dispersion tool.