IKA ROCKER 2D digital - Manual (Page 15)

15
Adjusting the inclination angle of the shaking table
The inclination angle of the shaking table can be adjusted in steps of 2.5° from 2.5 - 15°.
Caution! Do not remove the cover (2) whilst the device is in operation!
Stop the device by pressing the "Start/Stop" button (F). Do not use your hand to stop the device.
Press the "Power" button (L) to switch the device off.
- Undo the screws (1) to remove the cover (2) at the rear of the device.
- Slacken the screw (3) and select the desired inclination angle (4). Tighten the screw (3) fi nger tight.
- Refi t the cover (2) and secure it with the screws (1).
3
4
Use of accessories
2
1
Operating modes A and B
Operating mode A
The device does not restart automatically when power is restored after a power outage.
Operating mode B
The device restarts automatically when power is restored after a power outage, using the set values, and displays the (Pr) symbol to
indicate that there has been a power outage within a certain period of time.
Switching between operating modes
To switch between operating modes, switch the device off, then keep the "Start/Stop" button (F) depressed and press the "Power"
button (L).