Snorkel TL49K-sn8000 User Manual

Page 21

TL49K 508159-000

4. Lower the Outriggers two at a time starting at the tow bar end (No’s 3&4) until

the jockey wheel just clears the ground.

5. Lower Outriggers 1&2 until the green LED display indicates that they are

under load. (As shown below)

Repeat this sequence for Outriggers 3&4.

By alternating from 1&2 to 3&4, carefully inch down each pair of Outriggers
until all four Outriggers are fully deployed, and the wheels are well clear of
the ground.

Now, by using the Level indicator (Fig.5), raise opposite Outriggers until the

bubble and indicator ring are concentric (i.e., the bubble rests in the centre).

9. Check that each LED on the Ground Control panel is still illuminated. This

indicates that each foot is in firm contact with the supporting surface.

Take EXTREME care NOT to ground either the Basket, or the
Jockey Wheel during the next step.

The unit is designed to operate on a supporting surface of
minimum bearing strength of 50N/cm

The maximum outrigger load is 12.5kN.

SETTING UP