Snorkel PAX10-sn0001 - Manual (Page 12)

OPERATOR‟S, SAFETY & MAINTENANCE HANDBOOK
9
Section 3
SAFETY RULES
NEVER exceed the rated capacity (Safe
Working Load or SWL) of the platform.
NEVER use this machine
as a „crane‟ (e.g.
by suspending loads from beneath the
platform).
NEVER make any attempt to increase the
working height or outreach of the platform
(e.g. by use of stepladders in the platform).
NEVER maneuver this machine on an
inclined surface otherwise it may become
uncontrollable.
NEVER maneuver this machine whilst in its
elevated position, as this may cause
instability.
NEVER maneuver this machine with a
person or materials in the platform.
NEVER enter or exit the platform unless
the platform is in the lowered and transport
position.
NEVER apply external side loads to the
platform or scissor structure.
NEVER allow persons at ground level to
operate the controls whilst the platform is
occupied (unless in an emergency
situation).
NEVER operate this machine outdoor, it
has not been designed to withstand wind
loading.
ALWAYS undertake the daily checks
recommended in this handbook prior to
operation of the machine.
ALWAYS ensure that all instructions,
warning and Safe Working Load decals are
clean and legible.
ALWAYS ensure the machine is positioned
on adequate ground to support the weight
of the machine.
ALWAYS ensure that sufficient clearance
is given if working near to live conductors.
ALWAYS ensure that castor brakes have
been engaged before elevating the work
platform.
ALWAYS ensure that the platform does not
come into contact with fixed objects (e.g.
buildings, etc.) or moving objects (e.g.
vehicles, other plant equipment, etc.).
ALWAYS replace any removable guard
rails (e.g. close & lock access gate) to
enable full edge protection to be
maintained.
ALWAYS ensure that the load is evenly
distributed within the platform.
ALWAYS ensure the safety of persons that
may enter the area around the platform
(e.g. cordon off areas to prevent persons
entering the danger area).
ALWAYS ensure hands are within the
confines of the guardrails whilst elevating
the work platform.