Snorkel AB46RT-sn1000+ANSI - Manual (Page 7)

7
EMERGENCY TOWING
Perform the following only when the machine will
not operate under its own power and it is neces-
sary to move the machine or when winching onto a
trailer for transportation.
1. Insure that the platform is fully lowered, and that
the turret is rotated so that the platform is to the
rear of the machine.
2. Attach chain / cable of sufficient strength for
towing the machine to front or rear tie down lugs.
Chock wheels before disengaging hubs.
Machine may roll.
3. Refer to figure 6 and disengage all four drive
hubs. Remove two screws and center cap.
Reinstall center cap in the opposite direction.
4. When ready to move the machine, remove the
chocks. Tow or winch into position and replace
chocks.
5. Engage all four drive hubs by returning the center
caps to their original orientation.
DO NOT move the machine faster than 3
mph. Faster speeds will damage drive
components and void warranty.
Figure 5: Manual Turret Rotation
7 /
8
in. Ratcheting
Wrench
Turret Rotation
Gear Box
AFTER USE EACH DAY
1. Ensure that the platform is fully lowered.
2. Park the machine on level ground, preferably
under cover, secure against vandals, children or
unauthorized operation.
3. Turn the upper key switch to OFF, the lower key
switch to platform and remove all keys to prevent
unauthorized operation.
Center Cap
Drive Hub
Figure 6: Disengaging Drive Hub