sPOD TJ 2003-2006 Instructions Center Bracket - Manual (Page 2)

s POD Installation Instructions
2003 – 2006 Wrangler
www.4x4s-POD.com
2
Send wire harness and
terminals down through here.
• Now you are ready to attach the entire assembly to the windshield using the ¼-20 Phillips head screws and
lock washers. Tighten all 4 screws ( careful not to over tighten ) while watching the alignment of the unit
against the windshield.
• Guide wire harness through right side of the sPOD header unit. Keep the harness as close to the
windshield rubber as possible. If you purchased the air gauge kit, then place the air line under the plastic
pieces and lead it all the way down the windshield pillar and down through the dash on drivers side.
• Remove glove box and feed wire harness down behind glove box and out of the way for now.
• Now drill a 1” dia. hole where shown from inside of the Jeep below the glove box area.
• Install supplied grommet and feed connectors through the firewall into the engine compartment.
• Re-install the battery.
• Next remove the 4 counter sunk screws from the plastic to the bracket and slide the assembly off the
bracket before installing the Source mounting plate.
• Remove the two grounding terminal bolts using a 15mm socket located on firewall just above the
valve cover behind OEM harness and attach mounting plate. Be sure to reattach grounding
terminals! See below:
Drill 1 in. diameter hole here on
passenger side under glove box area.
Grommet Pull carpet back
Do not over tighten
4 counter sunk screws!
15mm ground bolts