Lukas Telescopic Rams - Manual (Page 3)

3
1 Safety instructions
Basic operation and designated use of the machine
1.1 The cylinders described below may only be used in combination with components from
LUKAS rerailing equipment. It is possible to operate them with devices from other manufacturers
-- however, this requires technical testing/approval by LUKAS in each individual case.
1.2 The machine is intended exclusively for driving and controlling rerailing equipments. Any
other use, e.g. driving and controlling other hydraulic equipment, is not according to specifications.
The manufacturer/supplier will not accept any liability for damage as a result thereof. The risk is
entirely to be borne by the user.
Use according to specifications also means that the operating instructions are observed and that the
conditions for inspection and maintenance are to be met (see also chapters 4 and 13).
1.3 The machine has been built in accordance with state-of-the-art standards and the recognized
safety rules. Nevertheless, its use may constitute a risk to life and limb of the user or of third parties,
or cause damage to the machine and to other material property.
1.4 The machine must only be used in technically perfect condition in accordance with its
designated use and the instructions set out in the operating manual, and only by safety-conscious
persons who are fully aware of the risks involved in operating the machine. Any functional disorders,
especially those affecting the safety of the machine/plant, should therefore be rectified immediately.
1.5 Device designation
2 Organizational measures
2.1 The operating instructions must always be at hand at the place of use of the machine, e. g.
by stowing them in the tool compartment or tool-box provided for such purpose.
2.2 In addition to the operating instructions, observe and instruct the user in all other generally
applicable legal and other mandatory regulations relevant to accident prevention and environmental
protection. This also applies for wearing protective clothing, helmet with visor or goggles and
protective gloves.
2.3 In order to avoid injuries, the machine must only be operated by a specially trained operator who
has undergone safety training. It is also important to consider the influence of stress factors on the
operator when working at the machine. These may constitute a risk to life and limb of the user or of
third parties, or cause damage to the machine and to other material property.
2.4 Observe all safety instructions and warnings attached to the machine. Make sure that safety
instructions and warnings attached to the machine are always complete and perfectly legible.
2.5 Never make any modifications, additions or conversions which might affect safety without the
supplier’s approval. This also applies to the installation and adjustment of safety devices and valves
as well as to welding work on load-bearing elements.
HP 25 T - 450 R
total stroke
in mm
hydraulic piston
retraction telescopic design
min. push capacity
in tonnes
high-pressure
cylinder