Lukas LAA Pulling Device - Manual (Page 2)

2
Safety instructions
1000 Basic operation and designated use of the machine
1100 The machine has been built in accordance with state-of-the-art standards and the recognized
safety rules. Nevertheless, its use may constitute a risk to life and limb of the user or of third parties,
or cause damage to the machine and to other material property.
1200 The machine must only be used in technically perfect condition in accordance with its
designated use and the instructions set out in the operating manual, and only by safety-conscious
persons who are fully aware of the risks involved in operating the machine. Any functional disorders,
especially those affecting the safety of the machine/plant, should therefore be rectified immediately.
1300 The machine is exclusively designed for longitudinal movement of loads. Using the
machine for purposes other than those mentioned above is considered contrary to its designated
use. The manufacturer/supplier cannot be held liable for any damage resulting from such use. The
risk of such misuse lies entirely with the user.
Operating the machine within the limits of its designated use also involves observing the instructions
set out in the operating manual and complying with the inspection and maintenance directives.
1400 An operating error could cause the destruction of the pulling device
2000 Organizational measures
2100 The operating instructions must always be at hand at the place of use of the machine,
e. g. by stowing them in the tool compartment or tool-box provided for such purpose.
2200 In addition to the operating instructions, observe and instruct the user in all other generally
applicable legal and other mandatory regulations relevant to accident prevention and environmental
protection.
This also applies for wearing protective clothing, helmet with visor or goggles and protective gloves.
2300 In order to avoid injuries, the machine must only be operated by a specially trained operator
who has undergone a safety training.
2400 Observe all safety instructions and warnings attached to the machine.
Make sure that safety instructions and warnings attached to the machine are always complete and
perfectly legible.
2500 Never make any modifications, additions or conversions which might affect safety without
the supplier’s approval. This also applies to the installation and adjustment of safety devices and
valves.
2600 Spare parts must comply with the technical requirements specified by the manufacturer.
Spare parts from original equipment manufacturers can be relied to do so. It is only allowed
to use original LUKAS spare parts or LUKAS system components.
2700 Replace hydraulic hoses within stipulated and appropriate intervals even if no safety-relevant
defects have been detected. This has to be done after 10 years at the latest.
2800 Adhere to prescribed intervals or those specified in the operating instructions for routine
checks and inspections.
3000 General safety instructions
3100 In the event of malfunctions, stop the machine immediately and lock it. Have any defects
rectified immediately.