Ruvati RVF1252RB - Manual (Page 6)

®
RVF1252RB
www.ruvati.com Printed in USA
1-855-4-RUVATI
Page 5
®
6. Unscrew both screws of the hose
weight until it is in two pieces. Place
one half of the hose weight on the
center sections of the spray hose.
Then place the remaining half of the
weight against the other half and re-
insert the screws. Do not tighten the
screws completely yet (Figure 5).
7. Connect the spray hose by
screwing it into the spray hose pipe
(Figure 6).
8. Make sure the spray hose weight is
vertical on the loosest section of the
spray hose and tighten the screws
with a Phillips-head Screwdriver to
secure it into place.
Figure 5
Figure 4
Figure 6
4. From underneath the deck/sink,
slide the rubber washer followed by
the metal washer all the way up the
threaded shank of the faucet (Figure
4).
5. Screw the locknut all the way up
the threaded shank of the faucet un-
til tight. Then using a Phillips- Head
Screwdriver, tighten the screws of
the locknut until tight (Figure 4).