Ruvati RVF1231ST - Manual (Page 5)

Hot & Cold Water Supply Hoses
®
RVF1231ST
www.ruvati.com Printed in USA
1-855-4-RUVATI
Page 4
Installation
®
Figure 3
Figure 2
Figure 1
2. Thread the spray hose and spray
hose connection hose through the
threaded shank and then screw the
threaded shank into the base of the
faucet body (Figure 1).
3. Place the faucet body into the
faucet hole of the deck/sink (Figure
2). A standard 1-3/8” hole is required
for this faucet.
5. Screw the locknut all the way
up the threaded shank until tight.
(Figure 3).
4. From underneath the deck/sink,
slide the rubber washer followed by
the metal washer all the way up the
threaded shank (Figure 3).
1. Remove rubber washer, metal
washer, and locknut from the threaded
shank (Figure 1). If you look closely,
you will find a black rubber O ring
sitting in a groove on the underside of
the base of the faucet, just above the
threaded shank. Do not remove this O
ring (Figure 1).