ADAM Audio MP1 - Manual (Page 10)

10
4. Speaker Adjustment
4.5 Bass Gain
The ‘Bass Gain’ raises or lowers the gain of the woofer up
to +/-6 dB.
4.6 High / Low Shelving EQs
Whereas the gains raise or lower the volume of a single
driver as a whole, the two room equalizers work differently.
The ‘EQ >6kHz’ is a shelving filter that progressively raises
or lowers the range above 6 kHz up to 6 dB. The ‘EQ
<150Hz’ does the same for the frequency band below 150
Hz (please see figures below).
4.7 LEDs
There are two diodes on the front panel. When the
loudspeaker is being switched on, the Overload-LED will
flash red a few times. This does not indicate an overload!
It signalizes the control function of the protective circuit.
Afterwards, the On-LED will start to glow green, indicat-
ing power on. Only if the Overload-LED flashes red during
operation, it does indicate an overload. Then, the protec-
tive circuit will be activated to prevent the speaker from
damage.
Room EQ <150 Hz for low
frequencies below 150 Hz Room EQ >6 kHz for high
frequencies above 6 kHz
On
Standby
EQ >6 kHz High Gain
OL
+6 dB +4 dB -6 dB -4 dB
MP1
EQ <150 Hz
+6 dB -6 dB
Mid Gain
+2 dB -2 dB
Bass Gain
+6 dB -6 dB
Input Gain
+10 dB -10 dB
On
Standby
EQ >6 kHz High Gain
OL
+6 dB +4 dB -6 dB -4 dB
MP1
EQ <150 Hz
+6 dB -6 dB
Mid Gain
+2 dB -2 dB
Bass Gain
+6 dB -6 dB
Input Gain
+10 dB -10 dB
On
Standby
EQ >6 kHz High Gain
OL
+6 dB +4 dB -6 dB -4 dB
MP1
EQ <150 Hz
+6 dB -6 dB
Mid Gain
+2 dB -2 dB
Bass Gain
+6 dB -6 dB
Input Gain
+10 dB -10 dB
On
Standby
EQ >6 kHz High Gain
OL
+6 dB +4 dB -6 dB -4 dB
MP1
EQ <150 Hz
+6 dB -6 dB
Mid Gain
+2 dB -2 dB
Bass Gain
+6 dB -6 dB
Input Gain
+10 dB -10 dB